Backpack System 1.0

The Backpack system 1.0 is a combination of a Packboard and a 90L Backpack. The Backpack is attached in the top of the Packboard and then secured in the bottom with Duffel attaches or a Duffel strap. You can carry a mortar tube, a mortar base plate, a drag bag, one or two AT-4 etc between the Packboard and the Backpack. The Backpack is then attached in the sides with Duffel straps. A Packboard lip can be attached to the Packboard to secure what you attach to the Packboard. The side pockets on the Backpack and the flap can be used as separate packs, attached to the Packboard.

The Pack Board solves countless carrying needs ranging from ammunition, weapons or weapon parts through containers and bulky items to oddly shaped burdens not easily fitted into a regular backpack.

Featuring the same proven and sturdy carrying harness as our classic 90 Litre Backpack, the Pack Board will stand up to heavy loads while still being ergonomic, comfortable and fast to handle. The Pack Board is developed with tactical considerations in mind, and is excellent for burdens such as e.g. 84mm munition cases, 60mm and 81mm mortars.

There is a dedicated bottom hole for wider barrel ends securing the burden centered and close to the carrier. The inside of the pack board flap is protected by Hypalon™ CSM, rendering a tough lining also resistant to chemicals, temperature extremes, and ultraviolet light. Each Pack Board is delivered with a set of long, sturdy straps to cover almost any need conceivable. In addition there are PALS/MOLLE webbings all over the Pack Board and the belt, where straps, pouches and packs will further extend the versatility of this excellent carrier.

Features

• Cut out in the backplate allowing bending the head back when wearing the backpack.
• Top tension straps.
• Place for owner identification Velcro patch.
• Ventilated back cushion.
• Shoulder straps with plastic sheet and firm foam for stability and comfort. This is the optimal solution with the plastic
• sheet distributing the pressure over the foam.
• Chest strap.
• Hip belt with plastic sheet and firm foam for stability and comfort.
• The hip belt is centre attached, and lets the pack adapt to body movements
• Side strap with side release buckles on hip belt
• Backplate supported by High density PE and aluminium rods.
• The inside of the pack board flap is protected by Hypalon™ CSM
• PALS/MOLLE webbing on flap, inside flap, and on hip belt of the carrying harness
• A set of three pairs of mounting straps
• Sturdy handle for lifting and dragging the pack
• Roll up ends on all straps.
• The integrated frame is reinforced with aluminium stays

Material

Fabric: 100% polyamide PU coated
Webbing: 100% polyamide or 100% polyester
Inner layer: 100% Hypalon™ CSM
Backplate inner: 2 mm high density polyeten.
Backplate rods: 100% aluminium

Dimensions

Height: 66 cm
Width: 34 cm
Weight: 3.1 kg